Stop Fighting With Your Blow Molder Lamps If you’ve ever tried swapping out heating lamps on a PET line, you know the headache. You move from...

Getting Your Sidel Matrix Heating Just Right Here is the problem when you swap out IR lamps in a Sidel Matrix blow molder: if the new lamps...

Getting Your Husky HyPET Heat Just Right If you’re running high-speed PET blowing, you know the struggle. You need that thermal profile to be...

Getting Heat Where It Actually Matters in Husky HyPET Systems Here’s the struggle with thick-walled PET preforms: if you just blast them with heat,...

Stop the Burn-Out on Your SIG Blomax Lines There is nothing more frustrating than a tube burning out right in the middle of a run. It kills your OEE,...

Getting Your Sidel Matrix Lamps Right Here is the real danger when you swap out IR lamps in a Sidel Matrix oven: you mess up the temperature curve....

Making Your SMI Blow Molding Lamps Just Work Let’s be honest: there is nothing more frustrating than being locked into one vendor because of some...

Stop Fighting With Your IR Lamps If you’ve spent any time as a blow molding engineer, you know the headache. A lamp goes out, and suddenly...

On the floor, every minute the SIPA XTRA sits idle is money you’re not making. When the heating tunnel starts drifting, preform stretch gets...

On the blow molding line, the heating tunnel is where the shift gets won—or lost. Preforms roll through on the carousel, and those infrared lamps...